Request for: Elite Marine Plywoods, Hardwoods, Teak & Teak Decking 1.        Marine plywood for different applications, different thickness; 2.        High Quality multi-laminate Mahogany Veneers throughout to give stability and durability. 3.        A lightweight panel with high quality faces on a core for applications where weight saving is important. 4.        A Hardwood throughout marine panel produced with veneers from Teak, Oak, Mahogany, Cherry etc. 5.        Teak Faced Marine plywood designed for external areas, locker lids, bulkheads or other structural work. 6.        Top quality ?A? grade veneers Teak, Oak, Mahogany, Cherry etc. on an exterior bonded (WBP) board either one or two sided for fitting out work on all types of boats. 7.        Teak decking with hard wearing 1.4mm thick 60mm wide Teak strips, this board has 5mm strips of non-slip rubber imitating a teak laid deck. 8.        Prime Quality 60mm wide Teak strips with 5mm Holly Inlay strips. This board is designed for cabin soles and other internal areas. 9.        Non Slip and hardwearing laminate flooring/decking with 45mm Teak and 5mm white strips. Ideal for areas of heavy wear – Charter Boats etc. 10.        A lightweight bending plywood ideal for all fitting out purposes where sharp curves are required. 11.        Flexible Veneer Sheets Teak, Oak, Mahogany, Cherry etc. Cut Veneers on a flexible backing sheet. Great for facing both flat and curved surfaces. 12.        Veneers for cold molding Teak, Oak, Mahogany, Cherry etc. Request for: Adhesives 1.        BALCOTAN Single Part waterproof Polyurethane Adhesive 2.        Polymite (was Cascomite) Single Part water resistant adhesive often used for internal joinery in boat 3.        EXTRAPHEN (was Cascophen) (including Hardener) A traditional two part adhesive used for a variety marine applications.